Flying Wing Buratinu

191 (likes)
Download 12702 (views)
This product is available only if you have an account in My Mini Factory service

The Buratinu is a smaller derivate of the Buratino which was designed by Bil in St. Petersburg. Thank you Bil for the great design. With its pointed nose I was optimistic that I would manage the CG problem, which is always tricky with printed planes. The original has a wingspan of 1800 mm. I designed it for a wingspan of 1300 mm with slightly more sweep back. The video is on YouTube Detailed information about the development from the beginning and a lot pictures of the parts can be found on Recommended Print Settings Attention The wings are designed to print using 0.5 mm width, 4 bottom and 4 top layers, no infill, 1 perimeter only. Should you print thinner walls, the perimeter of the upper side will not stick well enough to the perimeter of the inner stiffening construction. If you apply thicker walls, the perimeters will not come out continuously in one uninterrupted turn. The layers must build up as if you were printing in spiral vase mode. Only then you get a smooth surface on the upper side. If unsatisfied with the results, try out 0.49 or 0.48 width in your slices settings. It depends whether you use Cura, Slic3r, S3D or what you have. I suggest you experiment with some tests before printing the whole thing. The second point is: Should you print lesser layer heights, the inner stiffening construction will not connect well to the top and bottom layers. You will suffer a gap inbetween. All wing parts: layer height =0,3mm, width =0.5 mm, 1 perimeter, no infill W1, W2: 4 bottom layer, 4 top layer W3 servo: 3 bottom layer, 4 top layer W4, W5: 3 bottom layer, 3 top layer W6: 3 bottom layer, 5 top Layer elevon inner: 6 bottom layers, spiral vase mode, no top layer elevon outer: 3 bottom layers, spiral vase mode, no top layer elevon joint: no bottom/top layer, spiral vase mode All fuselage parts: layer height =0,2mm, width =0.5 mm fuselage 1: 3 perimeters, 12 bottom layers, 3 top layers, 40% infill fuselage 2: 3 perimeters, 2 bottom layer, 3 top layer, no infill fuselage 3: 2 perimeters, 2 bottom layers, 3 top layers, no infill access panel and bracket layer height =0.2 mm, width =0,5 mm spiral vase, no top/bottom layer Specifications airfoils: own design wing span: 1300 mm wing chord: 480/140 mm CoG: 113 mm overall weight: 1245 g wing weight one side complet: 342 g wing area: 32 dm² wing loading: 39 g/dm² motor: Propdrive 28-36 1200KV static thrust: 1200 g (3S Lipo) battery: Turnigy 1800 mAh 3S 40~50C Lipo motor camber: tilted -1.5 degrees



This model have no reviews. Would you like to be the first to review? You need to print it first.