Zyltech 12V 30A Power Supply Cover

2 (likes)
2079 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

I recently bought a 12V 30A power supply from Zyltech to replace the old stock 20A one on my printer that ran rather hot. The Zytech one is much nicer, quiet and runs cool, but I needed a cover for the wiring. I wanted it to hold my power switch and A/C socket as well, much like my Ender 3 is set up. There's already a few good designs here that I could have made work, but I wanted to draw this one from scratch as a learning experience since I'm trying to move over the Fusion360. I'm using a socket and switch that I salvaged from an old ATX power supply that seems to be less common, so I've also included a "blank" cover that you can cut out the holes you need to work for you. Maybe someone will find it useful! I attached the cover using 3 M4x10 screws in the larger holes, and the one smaller hole on the left side matches one of the pre-existing M3 screws in the case, replace that screw with a M3x10 screw through the cover.   It prints fine without support if you're printer is decent at bridging. Mine printed great with PETG, PLA should be even easier.

Author:
keithluneau

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.