YETI Magslider spout cover

8 (likes)
3135 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

This is a replacement for a lost Magslider that covers a YETI lid. It requires a 3mmx12mm magnet to be inserted. There are two slider files - one where the magnet can be inserted partway through a print or one where you can glue in a magnet after it's printed. For the inserted magnet, I just used CURA's pause at height at the layer before the hole gets covered. Mine was layer 25. Your's may be different based on layer height used. The sample shown is where I did the inserted magnet. Note: Test the magnet on the lid first and mark it right side up before you insert it into the print, otherwise, the slide will repel instead of sticking. Used PLA for my print - handwash only. Not dishwasher safe.

About the author:
Q-Vision
Photographer and Graphic Artist by trade. Now discovering the joys of 3D printing and the challenges of creating 3d models.

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.