Worm Gear Educational Aid

10 (likes)
2636 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

This is a fully printable worm gear model set up to be an educational aid and was created for a project at Michigan Technological University. The worm is very difficult to print and took me a few trys, I recommend using very small layer height instead of support. As you can see there are some imperfections on the worm from pulling support material off. Also you will need glue to mate the shaft to the worm, the knob to the shaft, and the shaft holders to the base. 

Author:
ChuckZ268

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.