Uchwyt szpuli na szynie

1 (polubienia)
1594 (odsłony)
Ten produkt jest dostępny tylko jeśli posiadasz konto w serwisie My Mini Factory
×
Kolor:

This is a slim and scalable sliding Spool holder.  Print as many rails as needed and secure with drywall screws to make as long a rail as possible.  This is compatible with Joel the 3D Printing Nerd's shelf design.  Print as many carriages as you want and slide them on.  If they need to move them by sliding them.  This is designed to print with no supports and with the layer orientation in the correct way to ensure strength. Unfortunately, I only have a Tronxy X1, so the rail section is small. The Spool holder an be scaled on the z to make the curve less sharp. You will need three 608 skateboard bearings to make this. I added a slimmed down version for small spools that should still fit larger one too

Autor:
KeithAckermann

Opinie

Ten model nie ma recenzji. Chcesz być pierwszym recenzentem? Najpierw musisz wydrukować model.