Spice shelf (Warning! Bridging torture built in!)

9 (likes)
1290 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

Warning! Make sure your printer can handle long bridges before printing! This is a three shelf model measuring 250 mm wide 150mm front to back and 100mm tall. I would suggest printing with a brim. Other than that no supports are needed, I've included two support pillars in the middle that can be removed after printing. Much bridging will be done and the underside may not look pretty! The side walls are approximately 2mm so bear that in mind if scaling. It may be a long print. I would suggest .2mm layer height 1.2mm shells 1.2mm top and bottom. 20% infill

Author:
Sagittario

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.