Dualshock 4 Thumbstick Cover

5 (likes)
1638 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

The rubber on my controller's thumbsticks degraded and fell apart within about year or two with just light infrequent use. This is a replacement designed to be as close as possible to the original size and shape. I believe the rubber composite was changed at some point and this issue went away.This is designed as a tight fit over a thumbstick without any rubber left around the outside and it will not fit over intact thumbsticks. The rubber on the top of the stick is bonded on far better but should not interfere with the fit of these covers.Best printed at a low layer height, I used a brim but you might get away without one. Supports probably needed for the inside, I printed mine with a support roof but your milage may vary depending how well your printer can keep the overhang from sticking to the roof.Sanding recommended.

Author:
TaneLattanzio

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.