CREALITY CR10S FRAME BRACKET (15X15 ALUMINUM BARS)

9 (likes)
2753 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

Frame brackets for creality cr10s to use with 15x15 mm aluminum bars.I did it to make the frame stiffer, reduce vibrations at higher part of the gantry that might affect taller prints.Top part has a high clearance that i needed for my e3d v6 hotend upgrade.Holes are 6mm diameter and i used M5 bolts and nuts and t nuts.I used M5x12mm and M5x30mm and washers to spread the load around the holes. 15x15 bars are under 60cm long (i think 59cm should work) but first fit the brackets and then put in the bar and mark it for cutting and drilling. Tolerances are tight and make sure that your printer is leveled. Print it with flat surface placed on the bed.

About the author:
samster_3d
     

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.