Cord protector for server cabinet

0 (polubienia)
31 (odsłony)
Ten produkt jest dostępny tylko jeśli posiadasz konto w serwisie My Mini Factory
×
Kolor:

This was designed to protect the cable of my surge protector that I keep in the bottom of my Black Box server cabinet that acts as a printer cabinet.  There are oblong knock-out plates on the upper and lower corners, and this cable protector fits snugly inside the knock-out plate to keep the cable from rubbing against the sharp sheet metal and therefore fraying. The protector fits snugly in the lower radius of the hole by rotating into place, and has a channel running around the perimeter to fit around the sheet metal.  The cutout for the cord is angled to allow you to better position the cord; mirror it if you want it going the other direction. Print in PETG for best durability, but PLA should work fine as well.  I printed with the flat (top) edge against the print bed, and with a brim and supports for the arch. -- If you like my work and want to support me, please check out my online store, become a patron, or buy me a coffee. Thank you! -- Licensed for personal use only. Commercial licenses available here. Please do not redistribute this file or any modified derivatives of this file in any way, or sell your own prints made from this file. Thank you.

Autor:
StephanieCerviDesign

Opinie

Ten model nie ma recenzji. Chcesz być pierwszym recenzentem? Najpierw musisz wydrukować model.