Nintendo Switch Dpad Mod 1.5

36 (likes)
7053 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

Proof: https://www.youtube.com/watch?v=CCQsaBZe-lI&t=18s This my first mod for the upcoming Nintendo Switch especially for the left Joycon controller. There are 6 different designs.  All of them have a little half-sphere pivot on the bottom to allow the mod to act almost like an actual dpad. You'll have no problem rocking around the dpad to perform combo and stuff. Since the face buttons are a bit asymmetrical), each of the dpad has a little nub on the side of the "UP" button as a guide to install properly.   For installation, use double sided tape or adhesive putty and apply onto the C buttons.

About the author:
EmperorFaiz
Just a regular bachelor student doing 3D printing stuff for fun and profit.

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.