toilet board distancer

1 (likes)
520 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

don't you just hate it when you have to replace the whole wc board 'cause those plastic distancers pop out and get lost, or break up, crumble... freecad source available, the values are not in separate table but there are 2 sketches in total so really super simple to change size in freecad or just rescale in the slicer to get proper size for your board I'm printing them 0.3mm layer, some hard tpu from hobbyking (much softer than regular plastic but not nearly as soft as those fully flex filaments like ninjaflex) at 80% gyroid infill and 0.4mm line width 4 perimeters (I use ideamaker that adds additional wall thickness in the 45 degree area so depending on the slicer you might want to add more perimeters) no supports required (45 degree overhang)

About the author:
BogdanKecman
Software Engineer (MySQL Cluster specialist, High Availability and High Reliability systems consultant, Security consultant, System Architecture consultant.. currently employed by Oracle) Electronics Engineer (microelectronics, impulse/digital design, power design ...) RepRap Core memeber since March 2nd 2010. ex thingiverse account: https://www.thingiverse.com/BogdanKecman/about

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.