pick locket

27 (likes)
2533 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

Here is a small container to keep picks in. The lid swivels open on a pin and then snaps back into place.  There are two versions of the pin--one has a slightly larger diameter than the other one--because I've found that not all my filaments print out to exactly the same size. The pin should fit snugly enough that pliers or a hammer tap is needed to seat it completely. A raft is strongly advised for printing the pin. Otherwise no supporting material is necessary. There is also a small hole in the top for stringing it on a cord if desired.

About the author:
gigi1970
Engineering tech by day, filament junkie by night.

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.