Death Star Inspired Laser pointer housing

18 (likes)
5441 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

My version of a Death Star, it is hollow with a high powered laser pointer mounting area. button oposite of the emitter to turn on rear activated laser pointers. Laser pointer cavity is 6" x 1.15" (152mm x 29mm) if you have a smaller rear activated laser pointer you have to make a filler for your laser pointer. I connected the 3 pieces with magnets for easy access to the laser pointer. measures approximately 8" (203mm) in diameter. The test print was at a lower facet count, than the file I am sharing about 100x smaller facets than the test print. middle piece and button will need a small amount of support, top and bottom should not need any.

About the author:
airlight74
I have been in residential, commercial, and mechanical design on AutoCAD since 1989. My 1st 3D design in autoCAD was in 1992. Since then I have done hundreds of 3D designs, mostly for buildings I was designing parts or all of. A few years back I started designing costume pieces for my friends. All my pieces were designed on AutoCAD but built by hand from leather, wood, metal or any other material I needed, or could use. Now that I own a 3D printer I am adjusting (in some cases more than adjusting) the drawings to make them 3D printable and will put them up as I finish each. Most of the drawings were top, sides, bottom and front, not in 3D so will take longer to get ready to share. most of what I will place here 1st is items that I originally drew in 3D or need very little work to adjust into 3D.

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.