Ouchi - Reuse your fillement offcuts

4 (likes)
405 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

Inspired by succulents and cacti this tippi tree ornament adds the stakes of glass ornament decorating to your tippi christmas; watch where you're stepping!The thorns are not printed, use the offcuts from standard 1.75mm fillament to press fit them on. Endless colours and as a bonus it helps get a use out of those small strands of fillament. You can even hang your nozzle clogs from the bottom as cactus fruit. You can also get creative and bend the fillament to get interesting lines by heating it up (do this with adequate ventilation) or add any trinket,small flower etc by modeling (or drilling) a 1.75mm hole through the mesh and using fillament as a stem. Prints with no supports, however some overhangs are a bit tricky so I would print with 0.2mm layer height. When slicing some small details may look like they print on air but I had no trouble printing other than the occasional tiny blob. I have included a couple of models to acommodate different printer tolerances. If you are unsure the 0.2mm tolerance should work for you. Takes about 10g of fillament at 10% infill

Author:
KostasF

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.