Ender 7 rear cover with cable loom support V2

1 (likes)
955 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

This is a rear top cover with cable loom support for the Ender 7. This fills the gap in Ian's excellent Ender 7 top cover. The stepper motors are now covered and the cable loom is supported. Minimal support is required if printed with the cable entry hole on the bottom. Will fit on an Ender 3 Pro build plate when at 45 degrees to the build plate. Will require glueing or screwing to the original parts. A zip tie around the cable sheath should prevent it from pulling out of the hole. Enjoy, Mike. UPDATE: It has been brought to my attention that the original did not print properly, the side tabs were not attached to the main body. This has been fixed and uploaded as a V2 version.

Author:
mcrummy

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.