Spray can handle/trigger

1364 (likes)
24672 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

I made this at the request of someone from of the many 3d printing facebook groups I am a part of. This is a all in one spraycan handle/trigger. I printed both versions without supports, however the curved model may look a bit bad surface finish wise. The V2 removed the curve and changed the angle of the trigger while being printed. Since this is a pressfit solution I recommend printing out the small pressfit tester first. Just to see if the pressfit will reproduce on your printer. Other problems could include the trigger fusing with the handle. I've not had it happen, but it's possible. You can check out my video below of it in use. https://www.youtube.com/watch?v=IxVCsVSmEsw 

About the author:
FilamentCorner
I am merely a simple maker sharing my designs and ideas with anyone willing to make them.

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.