Sabre stand base remixed

3 (likes)
564 (views)
This product is available only if you have an account in My Mini Factory service
×
Color:

The base is remixed to fit the LED rings that are suggested by original author. Further remixes could be done to fit the controller inside. Other files have not been changed. While soldering, put LED rings upside down and connect them. Connect DO with DI (Data Out and Data In), 5V and G, respectively, then put 2-sided tape on them. This is the controller I am using for the build: https://www.amazon.de/gp/product/B07DG2M4KD. Connect it to 5V, G and DI on the outer ring. You may also change the connector to micro-USB (get this extension cable, cut the micro-USB port (leave 5 cm cable with it) and solder it to the controller - now you can use any micro-USB charging cable you have. I recommend 5mm wide LED strip for the top part, something like this: https://www.amazon.de/gp/product/B07RBVKLPX Flip the rings and lightly press them into the base - done! Setup uses around 0.8-1A, so 1-2A (1000-2000mA) USB charger is required.   History: v1: base stand remix to fit the LED rings inside. 

Author:
4k

Reviews

This model have no reviews. Would you like to be the first to review? You need to print it first.